Spacers, Beads & Anchors

The B-series plug suits a wide range of bases — from solid to hollow building materials (concrete, masonry brick, aerated concrete, hollow brick, block, etc.). Four expanding wings give a full grip in the material. Suitable for fixing light cabinets, PVC skirting, bathroom accessories, pipe clamps and similar jobs.

The A-series plug is made from genuine HDPE raw material and resists cracking. It is longer than comparable plugs, with increased load capacity. Side lugs keep in-wall rotation to a minimum. Produced in any required colour.

Cover spacer for bored (cast-in-place) piles. In pile work that strengthens the ground, it maintains the required distance between the soil and the reinforcement. This protects the rebar from the harmful effects of the surrounding soil.

Mesh corner bead for the outer corners of interior walls. Its meshed wings give a firm bond when gypsum, plaster or similar are applied. It protects external corners from impact and gives them a clean, even finish. Made of PVC in 2.5 m lengths.

A plug for mounting all kinds of drywall fittings. It securely holds light cabinets, PVC cornices, switches, light chandeliers and bathroom and kitchen accessories. The threaded entry in its head makes installation extremely easy.

A strip for forming joints (grooves) in reinforced-concrete structures. Made from recycled PVC.

Butterfly (spring-toggle) plug for mounting all kinds of drywall fittings. It provides the best hold for light cabinets, PVC skirting, cornices, switches, light chandeliers and bathroom and kitchen accessories.

A chamfer strip for forming a bevel on the corners of columns and beams. Made of genuine PVC and impact-resistant. Produced in two versions — with and without wings. It can be reused many times.

Made for protection and safety. It fits onto tie-rod bars or projecting rebar on site. Produced in red and orange. Available in two shapes — mushroom-head and hourglass.

A chamfer strip for forming a bevel on the corners of columns and beams. Made of genuine PVC and impact-resistant. Produced in two versions — with and without wings. It can be reused many times.

A helical plug for fixing into aerated-concrete partition walls. Its reverse helix gives a firm grip in aerated concrete for any mounting job.

Made for protection and safety. It fits onto tie-rod bars or projecting rebar on site. Produced in red and orange.

The D-series plug is used in hollow brick, hollow block, solid brick, concrete and drywall. It securely holds bathroom and kitchen accessories, PVC skirting, chandeliers, cable trunking, switches and wall accessories. Used with wood and chipboard screws; the screw length is chosen to match the plug length.

Used to close tie-rod holes in plywood formwork. Its head makes fitting and removal easy.

The C-series plug gives the best result in solid (cast) concrete. It can also be used in hollow materials (hollow brick, block, aerated concrete, etc.). It delivers top performance when mounting PVC, plastic, wood, metal and insulation materials.

Used to close stud holes in plywood formwork. It can also close the holes in pipe end caps.

Fits onto the ends of the tie-rod tube that keeps the formwork at a set distance, and protects the tie-rod bar from concrete leakage. The angle and cavities in its head are easily filled with joint grout.

A tube that protects the tie-rod bar during wall concreting in steel and timber formwork. It lets the tie-rod bar be reused many times. Made in any required diameter and length.